CO₂ Laser Tube Antifreeze Usage and Winter Maintenance Instructions

CO₂ Laser Tube Antifreeze Usage and Winter Maintenance Instructions

CO₂ Laser Tube Antifreeze Usage Instructions

During winter or when the ambient temperature drops below 0°C, antifreeze should be added to the cooling water to prevent the water inside the CO₂ laser tube (hereinafter referred to as the laser tube) from freezing. Alternatively, when the machine is shut down, the water inside the laser tube should be completely drained.

When using antifreeze, please observe the following requirements:

1. Antifreeze Selection

Choose an antifreeze with the following properties:

  • Good fluidity

  • Strong freeze protection

  • Low volatility

  • Low corrosiveness

  • Good heat dissipation performance

The freezing point of the antifreeze should be at least 5°C lower than the minimum ambient temperature expected during operation to reduce the risk of the laser tube cracking due to freezing in extremely cold weather.

In general, higher antifreeze concentrations result in poorer fluidity and heat dissipation. Customers should select an appropriate concentration according to actual operating conditions.

Always handle antifreeze safely and follow the manufacturer's instructions.

Commonly available antifreeze is generally made by mixing ethylene glycol with water. The approximate relationship between ethylene glycol concentration and freezing point is shown below.

2. Ethylene Glycol Concentration and Freezing Point

No.Ethylene Glycol ConcentrationFreezing PointNo.Ethylene Glycol ConcentrationFreezing PointNo.Ethylene Glycol ConcentrationFreezing Point
120%-9°C440%-25°C751%-40°C
228%-15°C543%-31°C854%-45°C
334%-20°C646%-35°C960%-50°C

Note: Freezing points are approximate reference values. Actual performance may vary depending on the antifreeze formulation and product specifications.

3. Check Laser Performance After Adding Antifreeze

Before and after replacing the cooling water with antifreeze, carefully compare the laser tube's cutting speed and beam quality.

If any of the following problems occur after adding antifreeze, it may be affecting the laser tube's output power or beam quality:

  • Reduced cutting speed

  • Unusual noise when cutting acrylic

  • Noticeable deterioration in laser spot quality

If these symptoms occur, stop using the current antifreeze and replace it with another suitable product after checking its compatibility with the laser tube and cooling system.

4. Replacing Antifreeze with Purified Water

When the ambient temperature rises above 0°C, replace the antifreeze with purified water in a timely manner.

Before refilling, completely drain the antifreeze from the following components:

  • Water chiller

  • CO₂ laser tube

Recommended

View all articles
CO₂ Laser Tube Operation Manual

CO₂ Laser Tube Operation Manual

The HANLEI CO₂ Laser Tube Operation Manual provides essential instructions for the installation, operation, and maintenance of CO₂ laser tubes. It covers electrical connections, high-voltage protection, cooling system requirements, operating current settings, safety precautions, routine maintenance, and common troubleshooting procedures.